Sketch will not upload

I am using 1286 topboard with a sketch and i cannot get the current sketch to upload. I have correct port and board selected. The Industruino flashes like it is uploading computor beeps as if the usb has been unplugged during the upload. The Industrino comes back on with the old sketch and the new sketch never gives and errors but just sits on uploading and never completes. Any help would be much appreciated. 

Derrick Sears
Derrick Sears
| 1 1 2
Asked on 2/24/16, 7:03 PM

Your answer

Please try to give a substantial answer. If you wanted to comment on the question or answer, just use the commenting tool. Please remember that you can always revise your answers - no need to answer the same question twice. Also, please don't forget to vote - it really helps to select the best questions and answers!

Ask a Question

Keep Informed

About This Forum

This community is for professionals and enthusiasts of our products and services.

Read Guidelines

Question tools

20 follower(s)


Asked: 2/24/16, 7:03 PM
Seen: 1977 times
Last updated: 2/24/16, 7:03 PM