I2C and Ethernet; 14 pin IDC breakout

For I2C, you use the 14 pin connector; I too am concerned about the use of I2C and Ethernet (this was asked here):

https://industruino.com/forum/help-1/question/expansion-pins-required-by-ethernet-module-152

What pins are free, if you use this board?  Any at all?  The spec sheet mentions that the interface uses SPI and i2c.

Industruino doesn't sell at breakout board; Winford sells one that seems like it will work; any other suggestions out there, especially if you have to use the Ethernet *and* I2C (if this is possible)?

http://www.winford.com/products/brk2x7.php

I2C
A
A
12
| 1 1 1
Asked on 3/14/18, 6:03 PM
1
vote
2127 Views

Your answer

Please try to give a substantial answer. If you wanted to comment on the question or answer, just use the commenting tool. Please remember that you can always revise your answers - no need to answer the same question twice. Also, please don't forget to vote - it really helps to select the best questions and answers!

Ask a Question

Keep Informed

About This Forum

This community is for professionals and enthusiasts of our products and services.

Read Guidelines

Question tools

43 follower(s)

Stats

Asked: 3/14/18, 6:03 PM
Seen: 2127 times
Last updated: 3/14/18, 6:03 PM