Using jumper in Industruino Proto Pin 13 (backlight)

Hey guys, I have a problem, recently I purchased an Industruino Proto Kit. I have a project that is using every IN/OUTPUT of the board and I need just one more, in the documentation PIN 13 says "Shared with LCD backlight/Disconect using jumper", but in the board doesn't seems to be any jumper (or I'm not seeing it), maybe I should put the jumper myself? if that so, where I should i conect it? I haven´t found any diagrams for that.

Thanks for your help.

Best regards.

Pablo Bustos
Pablo Bustos
7
| 0 0 0
Asked on 7/31/15, 9:25 PM
0
vote
2496 Views

Thanks for your answer Loic, I'll do that.

Pablo

Pablo Bustos
Pablo Bustos
7
| 0 0 0
Answered on 8/4/15, 4:35 PM
0
vote

Dear Pablo,

For the 32u4 topboard you can remove resistor R10 (large 1206 resistor) from the topboard to disconnect the backlight from D13.

Cheers,

Loic

 

Loic De Buck
Loic De Buck
1263
| 3 1 3
Answered on 8/4/15, 4:13 PM
0
vote

Your answer

Please try to give a substantial answer. If you wanted to comment on the question or answer, just use the commenting tool. Please remember that you can always revise your answers - no need to answer the same question twice. Also, please don't forget to vote - it really helps to select the best questions and answers!

Ask a Question

Keep Informed

About This Forum

This community is for professionals and enthusiasts of our products and services.

Read Guidelines

Question tools

11 follower(s)

Stats

Asked: 7/31/15, 9:25 PM
Seen: 2496 times
Last updated: 8/4/15, 4:35 PM