Factory hard reset of a severely bugged D21G

Hi all,

I have a D21G who does not get much farther than its startup, since the code within has a problem. It stays in limbo there, not being able to get to the end of its first loop. The problem is : its USB comm port is stuck too (he is not identified as anything on the USB port, which works perfectly with another D21G I have).

I have tried pressing the reset button during loading : no way. Holding the reset button during powering up (works with some arduinos) : no more success. Loading an empty sketch and holding the reset during loading ...

Is there any known way just to erase the whole memory of the thing so I would start from some firm base ?

Any idea welcome (nothing too esoteric, an no axe wielding, please)

Didier

Comment

Didier DORGUIN

172

| 4 1 3

Asked on 7/23/18, 4:39 PM

vote

2716 Views

vote

Hi Didier,

Please try double tapping the reset button on the back of the topboard, the backlight should continue to blink and the serial port should appear. Then upload a very simple sketch such as Blink, it should restore your board.

Cheers,

Loic

Comment

Loic De Buck

1263

| 3 1 3

Answered on 7/25/18, 3:41 PM

vote

Hi Loïc ! Worked ! I did it during reload and the D21G was its former self once again ! Thanks a bunch for the tip ! Didier, DG2R

Comment

Didier DORGUIN

172

| 4 1 3

Answered on 7/30/18, 6:06 PM

vote

Your answer

Please try to give a substantial answer. If you wanted to comment on the question or answer, just use the commenting tool. Please remember that you can always revise your answers - no need to answer the same question twice. Also, please don't forget to vote - it really helps to select the best questions and answers!

Ask a Question

Keep Informed

About This Forum

This community is for professionals and enthusiasts of our products and services.

Read Guidelines

Question tools

44 follower(s)

Stats

Asked: 7/23/18, 4:39 PM
Seen: 2716 times
Last updated: 7/30/18, 6:06 PM