Type of debug port on SAM D21G

Under the SAM D21G topboard is a 2x5 pin 0.05" connector. What type of debug port is it? Which modes are Supports? Is a schematic available?

Dirk Grebe
Dirk Grebe
12
| 3 1 2
Asked on 5/2/17, 6:31 AM
1
vote
2661 Views

Hi Dirk,

The debug port is a SWD port (same as on Arduino Zero). You can use for example an Atmel ICE debugger to connect to it.

The Arduino IDE currently doesn't support any debugging modes, only programming of sketches and bootloader via the SWD port. Atmel Studio does support debuggin the Arduino Zero so it should be a small effort to get the Industruino D21G supported in Atmel studio. We will look into it.

Schematic can be found at the bottom of the D21G topboard product page. Here's a direct link to the schematic

Best Regards,

Loic

 

 

Loic De Buck
Loic De Buck
1263
| 3 1 3
Answered on 5/3/17, 9:08 AM
0
vote

Your answer

Please try to give a substantial answer. If you wanted to comment on the question or answer, just use the commenting tool. Please remember that you can always revise your answers - no need to answer the same question twice. Also, please don't forget to vote - it really helps to select the best questions and answers!

Ask a Question

Keep Informed

About This Forum

This community is for professionals and enthusiasts of our products and services.

Read Guidelines

Question tools

35 follower(s)

Stats

Asked: 5/2/17, 6:31 AM
Seen: 2661 times
Last updated: 5/3/17, 9:15 AM