How does one generate an output signal?

I've been playing with the demo code for our new ind.io but can't get it to raise any pins to HIGH.  I'm assuming that the CH1, CH2... labels correspond to pins 0, 1...  I've stripped the code down to the bare minimum writing HIGH and LOW to all the available pins.  But I don't see voltage on any of the channels.  What am I missing?  (Code below)

#include <Indio.h>
#include <Wire.h>

void setup() {
  // put your setup code here, to run once:
 pinMode(0, OUTPUT);
  pinMode(1, OUTPUT);
  pinMode(2, OUTPUT);
  pinMode(3, OUTPUT);
  pinMode(4, OUTPUT);
  pinMode(5, OUTPUT);
  pinMode(6, OUTPUT);
  pinMode(7, OUTPUT);
  pinMode(8, OUTPUT);
  pinMode(9, OUTPUT);
  pinMode(10, OUTPUT);
  pinMode(11, OUTPUT);
  pinMode(12, OUTPUT);
  pinMode(14, OUTPUT);
  pinMode(15, OUTPUT);
  pinMode(16, OUTPUT);
  pinMode(17, OUTPUT);
}

void loop() {
  // put your main code here, to run repeatedly:
 digitalWrite(0, LOW);
  digitalWrite(1, HIGH);
    digitalWrite(2, LOW);
  digitalWrite(3, HIGH);
  digitalWrite(4, LOW);
  digitalWrite(5, HIGH);
  digitalWrite(6, LOW);
  digitalWrite(7, HIGH);
  digitalWrite(8, LOW);
  digitalWrite(9, HIGH);
  digitalWrite(10, LOW);
  digitalWrite(11, HIGH);
  digitalWrite(12, LOW);
  digitalWrite(14, HIGH);
  digitalWrite(15, LOW);
  digitalWrite(16, HIGH);
  digitalWrite(17, LOW);

}

• Comment
• Close
• Edit
• Delete

Michael Mesford

Michael Mesford

37

| 2 1 2

Asked on 9/26/16, 11:52 PM

0

vote

3089 Views