Error in uploading sketch
Hello,
I am getting an error in uploading a sketch. I have downloaded all the libraries and the driver. I am running on Windows 7. The device appears, I can select the port and Industruino as my board. Still no luck uploading. I get a "CPU Reset" error at the end. I've copied and the error log below:
Sketch uses 9664 bytes (3%) of program storage space. Maximum is 262144 bytes.
Atmel SMART device 0x10010005 found
Device : ATSAMD21G18A
Chip ID : 10010005
Version : v2.0 [Arduino:XYZ] Aug 1 2017 11:04:45
Address : 16384
Pages : 3840
Page Size : 64 bytes
Total Size : 240KB
Planes : 1
Lock Regions : 16
Locked : none
Security : false
Boot Flash : true
BOD : true
BOR : true
Arduino : FAST_CHIP_ERASE
Arduino : FAST_MULTI_PAGE_WRITE
Arduino : CAN_CHECKSUM_MEMORY_BUFFER
Erase flash
done in 0.685 seconds
Write 9936 bytes to flash (156 pages)
[============ ] 41% (64/156 pages)
[======================== ] 82% (128/156 pages)
SAM-BA operation failed
An error occurred while uploading the sketch
[==============================] 100% (156/156 pages)
done in 0.099 seconds
Verify 9936 bytes of flash with checksum.
Verify successful
done in 0.010 seconds
CPU reset.
Hi, you can safely ignore the sam-ba error and it seems your sketch was uploaded successfully.
The easiest way to check is using the standard Blink example and change the LED_BUILTIN to pin 26 which has the LCD backlight. After upload, the screen will go on/off/on/off..
Your answer
Please try to give a substantial answer. If you wanted to comment on the question or answer, just use the commenting tool. Please remember that you can always revise your answers - no need to answer the same question twice. Also, please don't forget to vote - it really helps to select the best questions and answers!
Keep Informed
About This Forum
This community is for professionals and enthusiasts of our products and services.
Read GuidelinesQuestion tools
Stats
| Asked: 11/1/18, 4:43 PM |
| Seen: 3494 times |
| Last updated: 11/1/18, 11:22 PM |